LS2153 Emergency Stop Push Button Switch Lockout, Transparent PC, 20/30 mm Hole
Code: LS2153
Emergency stop push button switch lockout LS2153 made of high-strength transparent glass resin PC, measuring 50 x 47.3 x 50 mm with a 20 mm or 30 mm mounting hole. It is installed permanently over wall switches, change-over switches and other electrical controls; open the cover to operate, which prevents accidental touching. With a padlock applied, the button cannot be operated during maintenance.
Prices are sent in a quotation once you submit your cart, adjusted to your quantity and delivery location.
Key features
- High-strength transparent glass resin PC
- Permanent installation over the switch, open the cover to operate
- Prevents accidental touching
- Fits 20 mm or 30 mm mounting holes
Technical specifications
| Dimensions (L x W x H) | 50 x 47.3 x 50 mm |
|---|---|
| Mounting hole diameter | 20 mm or 30 mm |
| Padlock hole diameter | 8 mm |
| Material | Transparent glass resin PC |
Used in
Emergency stop push buttonsWall switches and change-over switches
BUYER'S GUIDE
Choosing Electrical and Pneumatic Lockouts
These devices isolate plugs, wall switches, push buttons, emergency stops and air supply connections that cannot be locked with a breaker or valve lockout.
- Measure plug size and cable diameter before choosing a plug lockout.
- Switch and push-button covers must fit the panel cut-out and leave no way to operate the control.
- For pneumatic lines, lock the quick-disconnect and release stored pressure before work.
- Isolating a control circuit alone is not energy isolation; lock the main energy source whenever the procedure requires it.
Summarised from the manufacturer's catalogue and the general requirements for lockout devices in OSHA 29 CFR 1910.147. Device selection must follow your written energy isolation procedure and site risk assessment.
More in this family
Technical data from the manufacturer's catalogue, page 20. Specifications may change; please confirm with our team before ordering.
